Welcome to Fenco Group
You have no items in your shopping cart.

PUMP VT7 - 12L @ 200BAR, 1450RPM, 28mm 'H' SHAFT

Product Code: VT7
V-TUF VT7 HIGH PRESSURE PUMP 200 Bar (3000 PSI); 12 litres per minute, Industrial Pump with 28mm HOLLOW Shaft. This pump has the perfect balance of pressure and flow for optimal cleaning performance.

Suitable for electric 28mm solid shaft shaft motors such as the MS.243 (240 volt) motor to run with a 05 jet or MS.4155 (415 volt) motor to run with a smaller jet for at pressures closer to 200 Bar , MS.113 (110 volt) motor with a 07 jet, (ALWAYS MAKE SURE the motor is running at least 15% within its maximum amperage).

Most mains water supplies can cope with flow rate of 12 litres per minute.
  • The V-TUF VT7 is supplied unloader valve. This pump MUST be fitted with an unloader valve.
  • 2 x Inlet 1/2F bsp ports – one ½F bsp port is supplied with a thermal overload.
  • 2 x Outlet 3/8F bsp ports - one ½F bsp port is supplied with a blanking plug
  • The VT7 pump comes lubricated complete with V-TUF PRESSURE LUBE PL500.
  • OPTIONAL EXTRAS: PL500 V-TUF Pressure Lube (for pump top up)
  • Note: the pressure must be set to unload at no more than 200 BAR (3000PSI). See safety note below:

    IMPORTANT SAFETY NOTE: BEFORE powering the system: 1. the unloader valve MUST be set at MINIMUM pressure; 2. The bypass port MUST be open; 3. Then set the unloader to the required pressure (which MUST be LESS than the maximum unloader pressure of the unloader valve AND LESS than the maximum pressure of your equipment); 4. Set the locking nuts so this pressure (the running pressure and the lock line pressure) cannot be exceeded.
  • CAUTION: This is high pressure equipment and if the above safety and set up rules are not followed, serious damage to equipment and injury to humans can occur. The caps and joints can be blown clean out of their threads which cause dangerous projectiles. Please be free to ring 01522 787978 if you need any assistance.
  • £495.00 excl tax
    + -